Search FAQs
Browse by Product
FAQ Home Page > USB > Adapters > TU2-ET100
Browse TU2-ET100 Questions
There are 9 questions found in this category:

  1. Does the TU2-ET100 (v3.0r) work with Mac OS/X 10.5?
    TU2-ET100 (V3.0r) will work with Mac OS/X 10.5.  To install the TU2-ET100: Connect the TU2-ET100 into an available USB port on your computer. Drivers will install automatically. “A new network interface has been detected” window appears.  Click “Network Preferen...
  2. I have Windows XP and I followed the instructions in the Quick Installation Guide to install TU2-ET100 (v3), however, at the end of the installation, the "Found New Hardware Wizard" prompted "Windows could not load the device driver for this hardware. The driver may be corrupted or missing. (Code 39)". After that, the screen shows a message "A problem occurred during the hardware installation. Your new hardware might not work properly.". How can I resolve this?
    If you are seeing the messages like the pictures above, please check the bottom of the TU2-ET100. If it shows "H/W:V3.0R", check the CD-ROM that comes with the TU2-ET100 and if it says "Version 3.1", please follow the instructions below to update the driver. Put the CD-ROM back to the co...
  3. I have a USB device, for example a printer or cable/DSL modem. Can I install the TU2-ET100(v3) on the device to make it "network ready"?
    Unfortunately this is not possible. The TU2-Et100(v3) requires drivers to be installed for use. It is not possible to install drivers onto your USB device....
  4. Is the TU2-ET100 (v3) Mac compatible?
    The TU2-ET100 supports Mac OS X 10.4.
  5. Is the TU2-ET100 (v3) Linux compatible?
    Linux is not a supported operating system. The following is the chipset for the TU2-ET100: AX88772. Check with the chipset manufacturer to see if Linux drivers are available....
  6. Is the TU2-ET100 compatible with the PlayStation 3, XBOX 360, Nintendo Wii or any other game console?
    The TU2-ET100 (v3) is compatible with the Nintendo Wii. The Wii is preloaded with drivers so no driver installation is required. The TU2-ET100 (v3) is not compatible with any other game consoles....
  7. When I verify the installation of the TU2-ET100, I see an exclamation point on my network adapter. What should I do?
    Go to Control Panel and double-click the System icon. Go to the Device Manager and expand the Network adapters heading. Double-click ASIX ax887722 USB2.0 to Fast Ethernet Adapter (the icon that has an exclamation point on it), and click the Driver tab. On the Driver tab, click Update Driver. Use 4. ...
  8. After successful installation of the TU2-ET100 USB Fast Ethernet, I connected my USB device into a USB slot, but it does not seem to work. What should I do?
    Make sure that the CAT-5 cable is connected properly into your switch, or broadband modem. Double check the connection at the other end of the CAT-5 cable, and verify that the cable is inserted properly into your TU2-ET100. Also, verify that your switch or your broad-band modem is getting any power....
  9. Can I connect or disconnect TU2-ET100 while the computer is on?
    Yes, you can connect or disconnect TU2-ET100 while the computer is on because the USB interface is Plug-and-Play compliant and hot-pluggable. ...