DO NOT upgrade firmware on any TRENDnet product using wireless connection. Firmware upgrade over wireless connection may damage the product. Please perform firmware upgrade with "wired" network connection only
Firmware : v1.2.8 Date: 3/2015 Note:
Added capability to restrict SNMP access to one remote IP address
Fixed SNMP issue not able to communicate over different IP subnets/routed networks.
With the setting below, wireless computer connected to 653AP SSID “TRENDnet653” would receive IP address from Router on Port 1.
When connecting to 653AP SSID “TRENDnet653_2”, the computer would receive IP from Router on Port 8.
The Switch that we used for this setup...
IEEE 802.3 (10Base-T)
IEEE 802.3u (100Base-TX)
1 x 10/100Mbps Auto-MDIX PoE LAN port
Power/Status, LAN, WLAN
Reset button – restores factory default settings
Active Ethernet (Power over Ethernet, IEEE802.3af )-48VDC/0.375A
Power adapter 12V/1A
6 watts (max)
Dimensions (Diameter x Height)
120mm x 50mm (4.72 x 1.97in.)
Operating: 0° ~ 45°C (32° ~ 113°F)
Storage: -20°C ~ 70°C (-4° ~ 158° F)
5% ~ 95% typical (non-condensing)
OFDM: BPSK, QPSK, 16-QAM, 64-QAM
DBPSK, DQPSK, CCK
Access Point, WDS Bridge, Repeater
4dBi Smart Internal Antenna
2.412 ~ 2.472 GHz
Web browser (HTTP); SNMP v1, v2c
Data Rate (Auto Fallback)
802.11n: up to 300Mbps
802.11g: up to 54Mbps
802.11b: up to 11Mbps
802.11n: 18dBm (typical) @ 300Mbps
802.11g: 18dBm (typical) @ 54Mbps
802.11b: 17dBm (typical) @ 11Mbps
64/128 bit WEP, WPA-PSK/WPA2-PSK, WPA/WPA2-RADIUS
1-11 (FCC), 1-13 (ETSI)
Multi-Language Quick Installation Guide
CD-ROM (User's Guide)
Power adapter (12V DC, 1A)
Information provided in this document pertain to TRENDnet products and is subject to change at any time, without notice.