The TRENDnet TI-UF11SFP supports 802.3af, 802.3at or 802.3bt draft. Please check detailed product specifications under the Product section of our website. If your device is not standard PoE compliant it will not be compatible with TRENDnet PoE power sourcing equipment. Many non-standard PoE devices ...
Each switch will have a maximum amount of power that can be supplied to powered devices. This is the overall amount of power for the entire switch. Please check detailed product specifications for PoE budget under the Products sections of our website....
Transmit and Receive connectors will be inverted on the remote side. The fiber will not link if you connect a Transmit and Receive interface to the Transmit and Receive interface on the remote side. TX to RX and RX to TX. ...
Please refer to the user's guide for dip switch function number. When connecting two fiber converters make sure they are both set to forced mode on the fiber port. If using LLCF or LLR only one side should be enabled. ...
To establish a link, both the fiber and copper ports must be connected. Connecting only the fiber cables will not produce a link. Gigabit converters must be connected to Gigabit on the copper side. They will not link to a Fast Ethernet copper port. On the fiber interface, the Transmit and Receive co...
While TRENDnet cannot guarantee compatibility with third party hardware, TRENDnet does not employ or implement proprietary mechanisms within our fiber converters. If the third party converter adheres to specifications and also does not use proprietary measures they should be compatible. ...
Fast Ethernet: 100Mbps (half duplex), 200Mbps (full duplex)
Gigabit: 2000Mbps (full duplex)
Data RAM Buffer: 1MB
Jumbo Frame: 9KB
MAC Address Table: 2K
Hardened components rated for extreme temperatures
Automatic address learning and address aging
Input: 48 – 56V DC
Required power supply: TI-S12048 (sold separately)
Max. consumption: 72W
Pin 3, 6, 4, 5 for power (+) and pin 1, 2, 7, 8 for power (-)
Power budget: 60W
Power and relay inputs, 4 pin
Wire range: 0.34mm^2 to 2.5mm^2
Solid wire (AWG): 12-24/14-22
Stranded wire (AWG): 12-24/14-22
Torque: 5lbs. – In / 0.5Nm / 0.56 Nm
Wire strip length: 7-8mm
1: reserved, no function
2: set SFP speed to 100Mbps or 1000Mbps
IP30 aluminum housing
-40 – 75°C (-40 – 167°F)
Max. 95% non-condensing
103.5 x 81.5 x 32mm (4 x 3.2 x 1.2 in.)
153g (5.39 oz.)
Shock (IEC 60068-2-27)
Freefall (IEC 60068-2-32)
Vibration (IEC 60068-2-6)
Quick Installation Guide
Removable terminal block
DIN-Rail and wall mount kit
All references to speed are for comparison purposes only. Product specifications, size, and shape are subject to change without notice, and actual product appearance may differ from that depicted herein.