Firmware Version: v1.00.09
Release Date: 06/2023
DO NOT upgrade firmware on any TRENDnet product using wireless connection. Firmware upgrade over wireless connection may damage the product. Please perform firmware upgrade with "wired" network connection only |
Note: - -Update SSH cipher 3des-cbc, aes128-cbc, aes256-cbc
Filename: TEG-3102WS_fw_v1.00.09.zip
SHA-1 Checksum: 22596A70033ABB0B1728B35CB5A44EBED9F42BFF
Date
6/23/2023
File Size
20.13 MB
Filename: EN_datasheet_TEG-3102WS_(v1.0R).pdf
Date
5/3/2023
File Size
1.29 MB
Filename: FR_datasheet_TEG-3102WS_(v1.0R).pdf
Date
5/3/2023
File Size
1.25 MB
Filename: GE_datasheet_TEG-3102WS_(v1.0R).pdf
Date
5/3/2023
File Size
1.15 MB
Filename: PO_datasheet_TEG-3102WS_(v1.0R).pdf
Date
5/3/2023
File Size
956.93 KB
Filename: SP_datasheet_TEG-3102WS_(v1.0R).pdf
Date
5/3/2023
File Size
878.67 KB
Filename: IT_datasheet_TEG-3102WS_(v1.0R).pdf
Date
5/3/2023
File Size
1.16 MB
Filename: EN_Non-PoE_Multi-Gig.pdf
Date
1/5/2023
File Size
3.48 MB
Filename: FR_Non-PoE_Multi-Gig.pdf
Date
1/5/2023
File Size
2.63 MB
Filename: GE_Non-PoE_Multi-Gig.pdf
Date
1/5/2023
File Size
2.62 MB
Filename: PT_Non-PoE_Multi-Gig.pdf
Date
1/5/2023
File Size
1.85 MB
Filename: SP_Non-PoE_Multi-Gig.pdf
Date
1/5/2023
File Size
1.87 MB
Filename: ITA_Non-PoE_Multi-Gig.pdf
Date
1/5/2023
File Size
1.82 MB
Filename: Multi-Gig_Web_Smart_Switch_Series_Users_Guide_060723.pdf
Date
6/8/2023
File Size
4.27 MB
PNG Image
File Size: 3.17 MB
Date: 1/6/2023
Download
PNG Image
File Size: 1.77 MB
Date: 1/6/2023
Download
PNG Image
File Size: 1.74 MB
Date: 1/6/2023
Download
A Switch cannot share an IP address provided by your ISP with multiple devices. You will need a Router to share your Internet service with multiple devices. The Switch can be used to expand the amount of available ports on your network....
The TEG-3102WS supports jumbo frames up to 10KB.
To share an Internet connection you will need a Router. The TEG-3102WS can be utilized to expand the available ports on your existing Router or network....
You will need to be running Cat-5e or higher cabling for 2.5GBASE-T.
Please check your network adapter's specification and make sure that it supports 2.5 Gbps. Also, check if your network cable is Cat-5e or higher....
Only managed or web smart switches will have reset instruction. Unmanaged Switches are not configurable and do not have settings to reset. Your Switch will have a reset button. This button is typically recessed and located on the front or the back of the Switch. You will need a small pin or paper cl...
You will find management login and default settings in the quick installation guide and user's guide. Included with the Switch is a hard copy of the quick installation guide. The user's guide is available for download from our website under the Support section....
Standards | - IEEE 802.1d
- IEEE 802.1p
- IEEE 802.1Q
- IEEE 802.1s
- IEEE 802.1w
- IEEE 802.1X
- IEEE 802.1ab
- IEEE 802.3x
- IEEE 802.3z
- IEEE 802.3ab
- IEEE 802.3ad
- IEEE 802.3ae
- IEEE 802.3az
- IEEE 802.3bz
|
Device Interface | - 8 x 2.5G Ports
- 2 x 10G SFP+ slots
- LED indicators
|
Data Transfer Rate | - Gigabit Ethernet: 2000Mbps (full duplex)
- 2.5G Ethernet: 5000Mbps (full duplex)
- SFP: 2000Mbps (full duplex)
- SFP+: 20Gbps (full duplex)
|
Performance | - Switch fabric: 80Gbps
- RAM buffer: 1.5MB
- MAC Address Table: 16K entries
- Jumbo Frames: 10KB
- HOL Blocking Prevention
- Forwarding rate: 59.52Mpps (64-byte packet size)
|
Management | - CLI (Telnet / SSHv2) for basic administration
- HTTP/HTTPS (SSL v2/3 TLS) Web based GUI
- SNMP v1, v2c, v3
- RMON v1
- Static Unicast MAC Address
- Enable/disable 802.3az Power Saving
- LLDP and LLDP-MED
- Virtual Cable Diagnostics Test
- IPv6: IPv6 Neighbor Discovery, IPv6 Static IP, DHCPv6, Auto configuration
- Dual image and configuration
|
MIB | - RMON MIB RFC 1271
- LLDP MIB IEEE 802.1ab
- RFC 1213 MIB II
- RFC 1643 Ethernet intf MIB
- RFC 1493 bridge MIB
|
Spanning Tree | - IEEE 802.1d STP (Spanning Tree protocol)
- IEEE 802.1w RSTP (Rapid Spanning Tree protocol)
- IEEE 802.1s MSTP (Multiple Spanning Tree protocol)
|
Link Aggregation | - Static Link Aggregation
- 802.3ad Dynamic LACP
|
Quality of Service (QoS) | - 802.1p Class of Service (CoS)
- DSCP (Differentiated Services Code Point)
- Bandwidth Control per port
- Queue Scheduling: Strict Priority, Weighted Round Robin (WRR)
|
VLAN | - 802.1Q Tagged VLAN
- Dynamic GVRP
- Up to 256 VLAN groups, ID Range 1-4094
- Private VLAN (Protected Ports)
- Voice VLAN (10 user defined OUIs)
|
Multicast | - IGMP Snooping v1, v2, v3
- MLD Snooping v1, v2
- IGMP fast leave
- Up to 256 multicast entries
|
Port Mirror | - RX, TX, or Both
- Many to one
|
Access Control | - 802.1X Port-Based Network Access Control, RADIUS, TACACS+
- Local Dial-In User Authentication
- DHCP Snooping
- Loopback Detection
- Trusted Host
- Denial of Service (DoS)
- IP MAC port binding
- Block unknown multicast
|
ACL IPv4 L2-L4 & IPv6 | - MAC Address
- VLAN ID
- Ether Type (IPv4 only)
- IP Protocol 0-255
- TCP/UDP Port 1-65535
- 802.1p
- TOS (IPv4 only)
- IPv4 Address and Mask (IPv4 only)
- IPv6 Address and Prefix Length (IPv6 only)
|
Layer 3 Features | - IPv4 / IPv6 static routing
- IP interfaces: Up to 6
- Routing table entries: Up to 32 (IPv4 / IPv6)
- ARP table (up to 128 entries)
- Inter-VLAN routing
|
Power | - Input: 100 – 240V AC, 50/60Hz, internal power supply
- Max. consumption: 152.3W
|
Fan/Acoustics | |
MTBF | |
Operating Temperature | - -0° – 40° C (32° – 104° F)
|
Operating Humidity | |
Dimensions | - 240 x 104 x 27mm (9.45 x 4.09 x 1.06 in.)
|
Weight | |
Certifications | |
Warranty | |
PACKAGE CONTENTS |
- TEG-3102WS
- Quick Installation Guide
- Power adapter (12V 1.5A)
|
All references to speed are for comparison purposes only. Product specifications, size, and shape are subject to change without notice, and actual product appearance may differ from that depicted herein.
Not Available in Europe