You can switch KVM channels by pressing scroll lock + scroll lock or num lock + num lock within two seconds. The Hot key sequence denotes that you hit the individual key consecutively, one at a time, not simultaneously. To switch to a specific channel, use the push buttons on the KVM....
The USB hub may be detected as an unknown device on your PC. Power cycle the KVM by disconnecting all sets of KVM cables at the KVM at the same time, then reconnect them. Make sure you provide ample time between switching channels to allow your PC to detect the hardware properly....
2048 x 1536 @ 60Hz
The TK-407K includes four sets of KVM cables.
2 sets: 1.2m (4 ft.)
2 sets: 1.8m (6 ft.)
TRENDnet does not recommend using any type of third party hardware between the KVM and your computers or the console hardware to minimize compatibility issues. Use direct, native, connections. The TK-407K is a VGA KVM and it is recommended to use VGA displays with a VGA video source....
TRENDnet cannot guarantee compatibility with third party KVM cables. If you encounter issues, verify that the KVM functions properly with the included KVM cables. ...
When switching you are essentially disconnecting your hardware from one computer and connecting it to the other. Please allow ample time for your PC to recognize and load the drivers for your console hardware. If your KVM is not responding please power cycle the KVM by disconnecting all the KVM cabl...
If you have any third party hardware between the KVM and your console devices or the computers, please remove them to rule out any interoperability issues. This would include any type of interface converter, hubs, extension cables or docking stations. If you are using third party cables please use t...
Unfortunately the Linux operating system will not allow for hotkey functionality. Please use the physical buttons on the KVM to switch computers. ...
This is caused by VMware quickly changing the keyboard's num lock and scroll lock state. This activates hot key switching. You can prevent this by ensuring the host computer and the VMware session are both set to the same num lock and scroll lock state. Running VMware in full screen mode should also...
Unfortunately this KVM is not an HDCP compliant device.
Yes, you can also initiate hot key functions using num lock + num lock.
Please refer to the following table.
TK-C06, TK-C10 & TK-C15
6 Ft.(1.83m), ...
- 2 sets of 1.2m (4ft.) USB KVM cables
- 2 sets of 1.8m (6ft.) USB KVM cables
|Cable Interface (all male)|
- To KVM
- 1 x VGA/SVGA HDB 15-pin
- To Computer
- 1 x USB (Type A)
- 1 x VGA/SVGA HDB 15-Pin
|PC Port Connectors|
- 4 x VGA/SVGA HDB 15-pin (female)
|Console Port Connectors|
- 2 x USB keyboard/mouse (type A)
- 1 x VGA/SVGA 15-pin HDB (female)
- Face panel push buttons, keyboard hot key commands or Windows-based client switching software*
- Windows, Linux and Mac.
- 167 x 80 x 28 mm (6.6 x 3.2x 1.1 in.)
- Operating: 0°C ~ 40°C (32°F ~104°F)
- Storage: -20°C ~ 60°C (-4°F ~140°F)
- Quick Installation Guide
- 2 sets of USB KVM Cables (2 x 1.2 m / 4 ft.)
- 2 sets of USB KVM Cables (2 x 1.8 m / 6 ft.)
All references to speed are for comparison purposes only. Product specifications, size, and shape are subject to change without notice, and actual product appearance may differ from that depicted herein.