Search FAQs
Browse by Product
FAQ Home Page > Surveillance > IP Cameras > TV-IP302PI
Browse TV-IP302PI Questions
There are 8 questions found in this category:

  1. What is the IR wave length for the TV-IP302PI?
    The camera supports 850nm.
  2. Can you disable the LED in the TV-IP302PI?
    To disable the LED, log in to the camera and click Setup > System Information. Toggle the LED Indicator to Off then click Apply. ...
  3. How do I setup motion detection with email in the TV-IP302Pi?
    Log in to the TV-IP302PI by entering https://192.168.10.30 into the address bar of your browser. You will be prompted to log in to the camera. The default username is admin and the password is the one created during the initial installation. Click Setup > Event Server, enter your Mail Settin...
  4. How do I setup motion detection in the TV-302PI?
    Login to the TV-IP302PI by entering https://192.168.10.30 into the address bar of your browser. You will be prompted to log in to the camera. The default username is admin and the password is the one created during the initial installation. Click Setup > Motion Detection. Click Area 1,...
  5. How do I view the TV-IP302PI remotely if it’s behind a router?
    Overview Please ensure you have followed the quick installation guide and have the camera setup and accessible on your home/office network. The following instructions are going to outline how to make a TV-IP302PI camera accessible over the Internet. We will start by assigning a unique static IP ...
  6. What type of speakers are supported?
    The speakers need to have an external power source and a 3.5mm jack.
  7. How do I reset my TV-IP302PI back to factory defaults?
    Remove power from the camera.Take the included electronic wire, plug one side of the wire into "Default" and the other side into "GND" on the terminal block as shown in the picture below. Resupply power to the camera.  Wait for approximately 30 seconds for the camera to rebootRemove the electronic...
  8. What does the green LED indicate?
    The green LED will flash when you power on the camera and when it is transmitting data. ...