How do I configure the TW100-BRV204/304 for a DSL, PPPoE, connection?
FAQ ID: 755 Updated: 1/30/2006 7:26:38 PM
1) Open your web browser and type the IP address of the TW100-BRV204/304 in the address bar. The default IP address is 192.168.0.1. At the login, enter your username (blank) and password (blank).
2) Click on Internet then WAN Port on the left hand side.
3) Choose PPPoE for the Login Method in the Login section.
4) Enter your username and password provided by your ISP (Internet Service Provider).
5) Click Save.
Note: After you save the settings you may need to power cycle the modem and Router.
1) Disconnect the power cycle from the modem and Router.
2) Wait approximately 15 seconds.
3) Reconnect the modem first and wait for it to boot up.
4) After the modem has booted up reconnect the Router.
Related FAQs:
- When I attempt to access http://192.168.0.1 with my web browser, an error message tells me "The page cannot be displayed." How can I get into the TW100-BRV304 web configuration page?
- How do I connect using a the Microsoft VPN Client?
- How do I configure a VPN tunnel with both sides having static IP addresses?
- I set up my Internet Connection Type and saved it, but I still cannot access the Internet with my PC. What should I do?
- How do I configure a VPN tunnel when one side has a dynamic IP address?
Attachments:
No attachments found.