How do I configure the TEW-690AP to repeat a wireless signal from my existing access point?

Login to the TEW-690AP by entering into the address line of your browser. If you have configured the TEW-690AP with a dynamic IP address use the current IP address assigned to it.

The default username is “admin” and there is no password by default.

Click on Wireless>Basic and enable Repeater Mode Support. Enter in the MAC Address of the access point you will be repeating off of. The SSID, channel and encryption values must match the access point you are repeating off of.

Click on Wireless>Security on the left hand side and ensure that the encryption values match the access point you are repeating off of.

FAQ ID: 2249
Created: 1/6/2011
Modified: 1/6/2011
No attachments were found.

Print this page
Email this to a friend

Was this answer helpful:
(1 = not helpful at all, 5 = very helpful)
1 2 3 4 5