How do I make it Wireless?

Step 1 First you will need to know the SSID of your wireless Router or access point, along with the Channel. If you are using any type of wireless security like WEP, you will need to know the key values.

Step 2 Launch your web browser (such as the Internet Explorer 6.0 used in this manual). Then, type (the default IP address) in the Address bar and press [Enter] to enter the Management screen of the Configuration Utility. Or use the IP address that you manually assigned to the Print Server.

Step 3 Click on Configuration on the top Menu bar and click on Wireless on the side bar.

You can now input the SSID and Channel or you can click on Site Survey. If you are using WEP Encryption, select the type of encryption and key in the value in Key 1 and Save.Note: The Encryption method and key value is case sensitive and must match your Router or access Point.

Step 4 Once you have saved the settings, unplug the Ethernet cable from the back of the Print Server and unplug the electrical power for 15 seconds then plug the power back in. Start the PS-Utility and see if the utility finds the print server. If it does, then the unit is wireless at this point. If not, plug the Ethernet cable back into the print server and confirm the Wireless information.

FAQ ID: 1571
Created: 5/5/2008
Modified: 5/5/2008
No attachments were found.

Print this page
Email this to a friend

Was this answer helpful:
(1 = not helpful at all, 5 = very helpful)
1 2 3 4 5