WAN Interface ActiveInactive
WAN Type
Loading! please wait....
Activate WWAN for Auto-Failover Enable
    Remote Host for keep alive: 
IP Mode
IP Mode
WAN IP Address
WAN Subnet Mask
WAN Gateway
Primary DNS
Secondary DNS
MTU (0 is auto)
NAT disable
Enable
Host Name
(optional)
ISP registered MAC Address
Connection Control
Maximum Idle Time seconds
MTU (0 is auto)
NAT disable Enable
Session
IPv6 DualstackEnable
PPPoE Account1
PPPoE Password
Primary DNS
Secondary DNS
Connection Control
Maximum Idle Time seconds
Service Name (optional)
Assigned IP Address (optional)
MTU (0 is auto)
NAT disable Enable
IP Mode
My IP Address
My Subnet Mask
Gateway IP
Server IP Address/Name
PPTP Account
PPTP Password
Connection ID (optional)
Maximum Idle Time seconds
Connection Control
MTU (0 is auto)
MPPE
IP Mode
IP Address
Subnet Mask
WAN Gateway IP
Server IP Address/Name
L2TP Account
L2TP Password
Connection Control
Maximum Idle Time seconds
MTU (0 is auto)
MPPE
IPv6 DualstackEnable
PPPoA Account
PPPoA Password
Primary DNS
Secondary DNS
Connection Control
Maximum Idle Time seconds
Service Name (optional)
Assigned IP Address (optional)
MTU (0 is auto)
NAT disable Enable
Data Encapsulation
VPI Number(range: 0~255)
VCI Number(range: 1~65535)
Schedule type
Dial-Up Profile Auto-Detection   Manual
Country
Service Provider
3G Network
APN(optional)
PIN Code(optional)
Dialed Number
Account(optional)
Password(optional)
AuthenticationAuto PAP CHAP 
Primary DNS(optional)
Secondary DNS(optional)
Connection Control
Maximum Idle Time     seconds
Allowed Connection TimeAlways By Schedule
Schedule Rule #    
MTU (0 is auto)
Keep AliveDisable
LCP Echo Request
Interval seconds
Max. Failure Time times
Ping Remote Host
Host IP
Interval seconds
Account
Password
Primary DNS
Secondary DNS
Connection Control
Maximum Idle Time seconds
Service Name (optional)
Assigned IP Address (optional)
MTU (0 is auto)
NAT disable Enable
Multicast
IGMP SnoopingEnable
VLAN TAGEnable   (range: 1~4094)

 
Copyright © 2012 TRENDnet. All Rights Reserved