Beacon Interval
Specify the Beacon Interval value. Enter a value between 1 and 1000. Beacons are packets sent by an Access Point to synchronize a wireless network.

RTS Threshold
Use this field to specify a value for the RTS Threshold. Enter a value between 256 and 2432.
This value should remain at its default setting of 2,432. Should you encounter inconsistent data flow, only minor modifications are recommended.

Fragmentation Threshold
This field is used to specify the fragmentation threshold. Enter a value between 256 and 2346.
If you experience a high packet error rate, try to slightly increase your Fragmentation Threshold. The value should remain at its default setting of 2,346. Setting the Fragmentation Threshold too low may result in poor performance.

DTIM Interval (Beacon Rate)
Specify the Beacon Rate. Enter a value between 1 and 255 that specifies the Delivery Traffic Indication Message (DTIM). A DTIM is a countdown informing clients of the next window for listening to broadcast and multicast messages. When the AP has buffered broadcast or multicast messages for associated clients, it sends the next DTIM with a DTIM Interval value. AP Clients hear the beacons and awaken to receive the broadcast and multicast messages.

SSID Broadcast
Enables and disables a Service Set Identifier broadcast. When enabled, the SSID of the Access Point is sent to wireless enabled devices on the LAN.

Transmission (TX) Rates
Select the basic transfer rates based on the speed of wireless adapters on the WLAN (wireless local area network).