How do I configure a VPN tunnel when one side has a dynamic IP address?

Use the following screenshots as a guide


PC1 (192.168.1.x)-BRV204 (dynamic) ~ BRV304 (–PC 2 (192.168.2.x) Simply match both ends information. After the connections are created, 192.168.1.x should be able to ping 192.168.2.x.

Important Note:

1. Please match Local/Remote Identity

2. Please match the Pre-Shared Key

3. Please match the Authentication and Algorithm

4. Dynamic side would be the Initiator for Direction

5. Static IP side would be the Responder for Direction

6. When there is a dynamic connection, it would be Aggressive Mode for Exchange Mode

Settings on BRV204

Settings on BRV304


FAQ ID: 751
Created: 1/30/2006
Modified: 1/30/2006
No attachments were found.

Print this page
Email this to a friend

Was this answer helpful:
(1 = not helpful at all, 5 = very helpful)
1 2 3 4 5