How do I configure the TW100-BRV204/304 for a Cable connection using a Static IP Address?

1) Open your web browser and type the IP address of the TW100-BRV204/304 in the address bar. The default IP address is At the login, enter your username (blank) and password (blank).

2) Click on Internet then WAN Port on the left hand side.

3) Choose None (Direct Connection) in the Login Method field in the Login Section.

4) If your ISP has registered the MAC Address of your computer that you are managing the Router from click on Copy From PC under the WAN PORT MAC Address field. This will copy your computers MAC Address to the Router. If you are not managing the computer from the computer with the registered MAC Address make sure you enter the registered MAC Address manually.

5) Choose Specified IP Address (Static IP Address) in the IP Address section.

6) Enter in the IP Address, Network Mask, Gateway and DNS server address that your ISP (Internet Service Provider) has assigned to you.

7) Click Save.

Note: After you save the settings you may need to power cycle the modem and Router.

1) Disconnect the power cycle from the modem and Router.

2) Wait approximately 15 seconds.

3) Reconnect the modem first and wait for it to boot up.

4) After the modem has booted up reconnect the Router.


FAQ ID: 743
Created: 1/30/2006
Modified: 1/30/2006
No attachments were found.

Print this page
Email this to a friend

Was this answer helpful:
(1 = not helpful at all, 5 = very helpful)
1 2 3 4 5