How do I configure the TW100-BRV204/304 for a DSL, PPPoE, connection?

1) Open your web browser and type the IP address of the TW100-BRV204/304 in the address bar. The default IP address is 192.168.0.1. At the login, enter your username (blank) and password (blank).

2) Click on Internet then WAN Port on the left hand side.

3) Choose PPPoE for the Login Method in the Login section.

4) Enter your username and password provided by your ISP (Internet Service Provider).

5) Click Save.

Note: After you save the settings you may need to power cycle the modem and Router.

1) Disconnect the power cycle from the modem and Router.

2) Wait approximately 15 seconds.

3) Reconnect the modem first and wait for it to boot up.

4) After the modem has booted up reconnect the Router.

FAQ ID: 741
Created: 1/30/2006
Modified: 1/30/2006
Attachments
No attachments were found.

Options
Print this page
Email this to a friend

Rate
(0.0)
Was this answer helpful:
(1 = not helpful at all, 5 = very helpful)
1 2 3 4 5