TRENDnet | Support | FAQ | TV-IP302PI | How do I reset my TV-IP302PI back to factory defaults?
How do I reset my TV-IP302PI back to factory defaults?
FAQ ID: 2996   Updated: 8/5/2013 12:02:08 PM

  1. Remove power from the camera.
  2. Take the included electronic wire, plug one side of the wire into "Default" and the other side into "GND" on the terminal block as shown in the picture below.

  3. Resupply power to the camera.  Wait for approximately 30 seconds for the camera to reboot
  4. Remove the electronic wire after the camera finishes booting.
Was this information helpful?
Related FAQs:
Attachments:
No attachments found.