How do I Sync my TPL-4052E units together?

Plug in your TPL-4052E adapters and reset them by pressing and holding in the Sync button for 15 seconds. After you have reset the adapters, press and hold in one of the Sync buttons for 2 seconds.† Within 2 minutes, press and hold in remote unitís Sync button for 2 seconds to pair them.

To add an additional unit, plug it in and reset it by pressing in the Sync button for 15 seconds. After it has been reset, add it to the existing powerline network by pressing and holding in the Sync button on one of the existing units for 2 seconds.† Within 2 minutes press and hold in the Sync button on the new unit for 2 seconds.† Repeat for additional adapters.

FAQ ID: 2964
Created: 7/18/2013
Modified: 7/18/2013
Attachments
No attachments were found.

Options
Print this page
Email this to a friend

Rate
(1.0)
Was this answer helpful:
(1 = not helpful at all, 5 = very helpful)
1 2 3 4 5