TRENDnet | Support | FAQ | TV-VS1 | How can I setup the camera using a Macintosh?
How can I setup the camera using a Macintosh?
FAQ ID: 2519   Updated: 10/3/2011 2:30:07 PM

The camera can be configured from a Macintosh through its web-based configuration page.  The camera's web configuration page can be reached by entering its IP address into a web browser.  For example, if the IP address is 192.168.10.30 you would access it by opening your web browser and entering https://192.168.10.30 into the address line. 

Please note that if you are not using Internet Explorer that Active X components will not load. For example, setting up the motion detection windows is not possible without Active X support.


Was this information helpful?
Related FAQs:
Attachments:
No attachments found.