How do I configure my camera to upload snapshots to an FTP server?

Log into the camera by entering the camera’s IP address into your browser.  The default IP address is http://192.168.10.30.  The default username and password are both “admin”.

Once you have logged into the camera click on Setup then the Action > Snapshot page and place a check mark into “Enable Snapshot.   Select the method of events to trigger FTP uploads, either event based for motion detection, continuous or on a schedule.  Enter in your FTP server information and apply the settings by pressing the ok button.  

FAQ ID: 2393
Created: 4/21/2011
Modified: 4/21/2011
Attachments
No attachments were found.

Options
Print this page
Email this to a friend

Rate
(0.0)
Was this answer helpful:
(1 = not helpful at all, 5 = very helpful)
1 2 3 4 5