How do I create a WDS link between two TEW-690AP access points?

Ensure that each TEW-690AP is configured for DHCP or has been assigned unique IP addresses to prevent an IP address conflict.

Both access points must be configured with the same channel and wireless encryption values.

Login to the TEW-690AP by entering http://192.168.10.100 into the address line of your browser. If you have configured the TEW-690AP with a dynamic IP address use the current IP address assigned to it.

The default username is ďadminĒ and there is no password by default.

Click on Wireless>Basic and ensure the channel is the same on both units. Enable WDS mode. Enter in the remote TEW-690APís MAC Address into the AP MAC Address field and click Apply.

Click on Wireless>Security on the left hand side and ensure that both units are configured with the same encryption values.

FAQ ID: 2248
Created: 1/6/2011
Modified: 1/6/2011
Attachments
No attachments were found.

Options
Print this page
Email this to a friend

Rate
(2.7)
Was this answer helpful:
(1 = not helpful at all, 5 = very helpful)
1 2 3 4 5