How do I setup and secure my wireless network?
Log in to the TEW-658BRM by entering http://192.168.10.1 into the address line of your browser. You will be prompted to log in to the router. The default User Name and Password are both admin, without the quotes. Click on Setup > Wireless Settings and then Basic On this page yo...
 
How do I log into the router and configure it?
Log in to the TEW-658BRM by entering http://192.168.10.1 into the address line of your browser. You will be prompted to log in to the router. The default username and password are both admin. ...
 
What is the default username and password on the router?
The default username and password for the TEW-658BRM are both admin.
 
How do I forward ports in the TEW-658BRM?
Log in to the TEW-658BRM by entering http://192.168.10.1 into the address line of your browser. You will be prompted to log in to the router. The default username and password are both admin. After you have logged in to the TEW-658BRM click on the Advanced > NAT page. Enable Virtual Se...
 
How do I reset the TEW-658BRM to factory default settings?
Press and hold in the recessed reset button on the back of the router for approximately 10 seconds while the power is on to reset the unit. The default login values are as follows. IP Address: 192.168.10.1 Username: admin Password: admin ...
 
When I attempt to connect to the router I am prompted for PIN. Where is this located?
This is referring to the WPS (WiFi Protected Setup) PIN. To find the PIN, do the following. Connect your computer to one of the LAN ports. Log in to the TEW-658BRM by entering http://192.168.10.1 into the address line of your browser. You will be prompted to log in to the router. ...
 
How can I control outgoing traffic to the Internet based on IP range and protocol?
Log in to the TEW-658BRM by going to http://192.168.10.1. The default username and password are both admin. Click on Advanced > Firewall > IP Filter. IP Filters: Check this box to enable IP filtering. Filter Name: Define a name for the Filter. Example: You can name the filter...