How do I configure the TEW-690AP to repeat a wireless signal from my existing access point?
Login to the TEW-690AP by entering http://192.168.10.100 into the address line of your browser. If you have configured the TEW-690AP with a dynamic IP address use the current IP address assigned to it. The default username is “admin” and there is no password by default. Click on Wirel...
 
How do I create a WDS link between two TEW-690AP access points?
Ensure that each TEW-690AP is configured for DHCP or has been assigned unique IP addresses to prevent an IP address conflict. Both access points must be configured with the same channel and wireless encryption values. Login to the TEW-690AP by entering http://192.168.10.100 into the address l...
 
How do I reset the TEW-690AP to default settings?
Press and hold in the reset button on the bottom of the TEW-690AP for approximately 15 seconds while the power is on. ...
 
How do I secure my wireless network?
When going through the setup wizard you are prompted to setup wireless security. Use WPA2 AES encryption values for 802.11n performance. You can manually secure the wireless network by doing the following. Login to the TEW-690AP by entering http://192.168.10.100 into the address line of your ...
 
What is the default username and password of the TEW-690AP?
The default username and password are both admin.
 
What is the default IP address of the TEW-690AP?
The default IP address is 192.168.10.100.