How to setup the Internet Camera for Remote Viewing over the Internet
OverviewPlease ensure you have followed the quick installation guide and have the camera setup and accessible on your home/office network. The following instructions are going to outline how to make a SecurView camera accessible over the Internet. We will start by assigning a unique static IP addre...
 
Can I disable the LEDís on the front of the camera?
Yes, under the System>Device Management page you can disable the LEDís. ...
 
How can I view the TV-612WN remotely if itís behind a router?
You will need to forward the port that the camera is using in the Router to the camera. By default this is TCP port 80. From a remote location you would enter in the public or WAN IP address of your Router into your browser. Note: Please ensure you have configured the camera with a valid default ...
 
What do the LEDís on the front of the camera represent?
LNK: This LED indicator lights steady orange when a valid Ethernet link is established. It blinks orange when traffic is received or transmitted through the Ethernet link. PWR: This LED indicator lights blue when the camera is powered on. It remains dark when powered off. ...
 
How do I reset my TV-612WN back to factory defaults?
Press and hold in the reset button on the back of the camera for approximately 15 seconds while the camera is on. ...
 
Can my TV-IP612WN and TV-IP612P camera use Power over Ethernet?
The TV-IP612P is a Power over Ethernet camera. The TV-IP612WN does not support Power over Ethernet.
 
How do I upgrade the firmware on the TV-IP612WN and TV-IP612P?
Download the latest firmware updates from our website here. http://www.trendnet.com/downloads/ Firmware Upgrade Procedures Go to cameraís configuration page directly via browser or using Setup Wizard to link. Enter user name and password when prompted. (default admin/admin) It is required t...
 
How do I setup motion detected recording?
Open your web browser and login to the camera. Click on Motion Detection to define the motion detection area and define the sensitivity. After defining the motion detection parameters click on Action>Recording. Define where you want the recordings to be stored and select Event based and ch...
 
What is the default IP address of the TV-IP612WN and TV-IP612P?
The default IP address is 192.168.10.30.